WPS Button On Router Not Working Solutions
When the WPS button on router not working or is greyed out/does not work on the router, you can fix this issue by enabling WPS on the router's GUI page. If that does not solve the issue, reset WPS or factory reset the router itself. You can locate the Reset button on the router's rear surface. Use a needle or pointed device to press and hold it for about ten seconds. Let go of the button and restart the router. To reset WPS, press and hold the WPS button for about twenty seconds and then let go of the button.
Netgear Router WPS Button Not Working
If you encounter a WPS button issue on your Netgear router, follow these guidelines to resolve Netgear router WPS button not working.
- Netgear router setup and wait until it initializes to solve WPS button on router not working.
Power on the
Try to configure and apply the wireless network settings. The 'WPS process is in progress' message appears.
Press the Netgear router's WPS button and hold it for about 30 seconds. The WPS LED glows without flickering.
Now, click Apply. This should resolve the Netgear router WPS button not working.
You can also try resetting the Netgear router. Log into the Netgear router's embedded web server page and check whether WPS is enabled. Do note, however, that you have to configure the Netgear router again.
WPS Button On Centurylink Router Blinking Red
If the WPS button blinks red, it means that the CenturyLink router setup has detected a session overlap. To resolve this WPS issue, follow these steps.
While the CenturyLink router is powered on, pull the power cable from its Power port. Check whether all its LEDs have stopped glowing. After a few minutes, reattach the CenturyLink router's power cable to the Power port and wait until the device initializes to solve WPS button on router not working. The WPS issue should now be resolved.
Sagemcom Router WPS Button Not Working
To use the WPS feature on your Sagemcom router, enable it by following these steps to solve Sagemcom router WPS button not working.
Enter '192.168.1.1' in the address bar (or the correct IP address mentioned in the Sagemcom router's label) and press Enter.
Enter 'admin' as the username and password and click Log in to solve WPS button on router not working.
The Sagemcom router's EWS page loads. Locate the WPS tab at the top of the page and click it.
Go to the WPS switch and click it. The WPS feature is now enabled on your Sagemcom router.
Make sure that the Push Button and PIN options are ticked. Click Apply to solve Sagemcom router WPS button not working.
To pair a network device with the Sagemcom router, press and hold the Sagemcom router's WPS button for 5 seconds. The network device should automatically connect to the Sagemcom router's network.
Arris WPS Button Not Working
Locate the Arris router's IP address and enter it in the address bar on your web browser. Press Enter. An alternative method to find the IP address is as follows. Press Win key & R at the same time to open Run.
Enter the word 'cmd' without quotes and press Enter. Type 'ipconfig' without quotes and press Enter. Locate the IP address that resembles '192.168.a.b.' Enter this in the 'address bar' of your internet browser and press Enter to solve Arris WPS button not working.
- Arris router setup EWS page loads. Enter 'admin' and 'password' as the username and password, respectively. Click Apply.
The Arris router's System Basic Setup page loads. Navigate to the 'Modify your Wireless security' tab to solve Arris WPS button not working.
Enable Wireless Protected Setup on this webpage. Now, you can press the WPS button on the Arris router and pair a mobile device with it to fix WPS button on router not working.