Ethernet Not Working On Ubee Router
The Problematic Scenario
Follow the instructions below for the user who are facing Ubee router ethernet not working issue.
When you use a wireless connection to access your Ubee modem/router, you are able to connect to all the websites. However, when you use an Ethernet connection, you are not even able to access your Ubee router/modem’s GUI. Shortly put, your Wi-Fi is working fine, but the Ethernet is not.
Now, you do not know what exactly is wrong with your Ethernet connection. You wonder if there is a problem with your Ethernet ports or the cables. You are stumped and would appreciate any help that would get your Ethernet connection up and running again.
The Solution To The Problematic Scenario
For starters, you can try the following usual tips to fix Ubee router ethernet not working issue.
Try to reconnect your Ethernet cable or attempt to plug the cables into different ports.
Next, try restarting your computer. If this does not work, you can restart your Ubee modem/router and check if that resolves the issue.
You can also make an attempt to reset your Ubee modem/router to the default factory settings. But keep this as a last resort (if all other techniques fail).
In case the common tips stated above fail to solve the problem, move on to the following techniques:
Check if your Ethernet and Wi-Fi connections are using the same Subnet mask.
- ipconfig. Here, you will be able to check your IP address, subnet mask, and gateway.
While you are connected via Ethernet, open the Command Prompt on your computer and type in
Next, change over to the Wi-Fi connection and check your IP address, subnet mask, and gateway using the same procedure.
- No operation can be performed on ethernet while it has its media disconnected” message after you type in the ipconfig command. If this is the situation, you can conclude that your Ethernet ports have died.
You can compare the above parameters on both your Ethernet and Wi-Fi connections. Then, you can go about fixing the issue accordingly. However, sometimes you might see the “
- TCP Ipv4 protocol. If it has been set to Static IP and DNS, try changing it to Automatic IP and DNS. This tactic has worked wonders for many users, and so it is highly recommended.
The above techniques should help in fixing the Ethernet connection issue while using your Ubee modem/router.
We have now discussed the “Ubee router Ethernet not working” issue.