Tenda FH1201 is a dual-band wireless router that has a link rate of 1200 Mbps. This router is equipped with high powered amplifiers, external antennas, and internal antennas. To perform the Tenda FH1201 router setup, proceed with the following step-by-step instructions.
Step 1
Step 2
Step 3
Connect the router’s power adapter to the power source and let it turn on.
Once you have done the hardware setup of your router, you have to configure it, so that it could get connected to the Internet. However, before configuring the Tenda Fh1201 router setup, you must configure the Internet settings on your computer that is connected to the router.
Step 1
Step 2
Step 3
Step 4
Step 1
On your computer, open the Microsoft Internet Explorer browser or any other browser.
Step 2
Enter 192.168.0.1 (router’s IP address) in the browser’s address bar.
Step 3
Once you see the router’s login window on the screen, enter the password and click the Login button.
Wait until your Tenda Fh1201 router setup detects the connection.
When you see the Your Internet connection type is DHCP message, click the OK button and proceed the Tenda router setup further.
Step 4
Step 5
Note: You can get the username and password from your ISP (Internet Service Provider).
Step 6
Step 1
Step 2
If you see the Cable improperly connected message in the Connection Status field, you have to check if the Ethernet cable is correctly connected between your router and the modem.
Once done with the initial setup of the Tenda FH1201 router, you can disconnect the Ethernet cable connected between the router and the computer.
Step 1
On your computer, navigate to the notification area and click the Network icon.
Step 2
Step 3
In the Security key field, type your network key and click the OK button.