COMPLETE GUIDE TO SETTING UP BELKIN ROUTER

The Belkin router can be set up by using the Belkin setup CD which was supplied with the router. If the computer doesn’t have a CD drive, you can setting up Belkin router via its EWS page after connecting it to the computer by using an Ethernet cable.

SETTING UP YOUR BELKIN ROUTER

Here are the steps for manually setting up a Belkin router.

setting up Belkin router

BELKIN ROUTER DEFAULT PASSWORD

The Belkin router default passwords are typically Admin, admin, and blank (which means you need to leave the Password field blank.) You can go to the Belkin router’s control panel and press the reset button for about twenty seconds to reset the password to factory default.

HOW TO SET PASSWORD ON BELKIN WIRELESS ROUTER

If you need to change or set a password on a Belkin wireless router, you can follow the guidelines given below after setting up your Belkin router.

BELKIN ROUTER GUEST ACCESS PASSWORD

Make use of the procedure stated below to change the guest access password.

HOW TO CONFIGURE BELKIN N150 WIRELESS ROUTER STEP BY STEP

  • Ensure that the modem is not connected to a power source. Attach an Ethernet cable between the modem and WAN port of the router.
  • Connect the Belkin N150 router and modem to the power outlet to setting up your Belkin router.
  • Open the default browser on your system and key in the IP Address of the Belkin router.
  • Tap the Enter key. Click the Detect My Connection button to setting up Belkin router.
  • Next, the router will check for firmware updates and download it to your system.
  • Click the Save and Continue button available at the bottom of the screen to save the credentials.
  • Click the Great, What’s Next button to proceed to the registration process.
  • Enter the necessary details on the next page. Click the Complete Registration button to finish the registration procedure.

CONNECT TO BELKIN ROUTER

BELKIN ROUTER HOOK UP

Perform the following steps for belkin router hook up,

Setting Up Your Belkin Router

BELKIN ROUTER RESET

Manual hardware reset.

Software reset,