Sometimes, you would have reset your Linksys router. But after the reset, your router might refuse to work. If this is the case, try the following reset my Linksys router and now it wont work troubleshooting methods:
Once you have performed the reset, your Linksys router’s Power LED continues to blink for some seconds. But, if it does not stop blinking even after one full minute, you have to power cycle the Linksys router.
So, unplug the power cable from the electrical socket. Please wait for 30 seconds. At the end of 30 seconds, plug the power cable back into the electrical socket.
Now to solve reset my Linksys router and now it wont work, check if the power adapter is plugged properly into the router. Also, check if the power adapter is correctly connected to the electrical socket. Your Linksys router might not work if any of these two connections is not proper.
If the above conditions are satisfied, your Linksys router will start working from now on.
If the problem persists, go to the next method.
Check Your Static/Dynamic IP-DHCP:
The Linksys router will not work if you have assigned a static IP to it, but enabled the DHCP server.
Now, on your computer, open the default web browser.
In the Address bar, type in 192.168.1.1 (IP address of your router).
Check whether the DHCP server is enabled. If yes, disable it to solve Linksys router not working after reset.
Check if your router’s IP address is static. If yes, your Linksys router should start working fine.
In case the router’s IP address is dynamic, enable the DHCP server again to solve reset my Linksys router and now it wont work. If the DHCP server is disabled, your router will work like a switch. In other words, it can let only one computer have access to the internet.
If you find that the Linksys router not working after reset problem is not solved even after trying the above method, try utilizing the one described below:
Make Use Of The Default Gateway To Get Connected To The Internet:
Only for a certain period, Parental Control is the right option to solve reset my Linksys router and now it wont work.
On your keyboard, press the Windows and the R keys simultaneously. This action will open the Run command box.
In the Run command box, type in cmd. Press the OK button.
The Command window will appear now.
On the Command Prompt, type in ipconfig. Then, press the Enter key.
The Command Prompt will display the Default Gateway.
Open the default web browser on your computer. In the URL bar, enter the default gateway.
When you are asked for your Username and Password, enter this information correctly.
Now, you will get a proper internet connection, which means that your Linksys router is working fine.
In case you are able to connect to the internet via your modem but not via the router, perform the following instructions:
First, connect the cable between your modem and router.
Next, use the LAN cable to connect your router to the computer.
On your computer, find the default gateway.
The method described above will help you fix the reset my Linksys router and now it wont work issue.