To enable the Wi-Fi Protected Setup feature on your Huawei router, you must sign into the web-based configuration site of the router. For entering into the setup page, you need to know the default IP address of your Huawei access point. Also, make a note of the username and password of your Huawei network router for signing into the login page. Simple guidelines on how to sign into the configuration website and turn On the WPS mode on the Huawei router are given below in this site.
Usually, WPS function supports three modes: Push Button Configuration (PBC), PIN input configuration (PIN), and AP PIN. Login into the WPS basic configuration page by following procedures given. Open an internet browser, type the IP address of your router in the search bar and click the Enter button. On the ONT, enter the login account name and password when prompted in the given field and click the Login button. Click the WLAN option and select WLAN Basic Configuration. The basic configuration process is done and now use any one of the modes listed above. To use the PBC WPS mode, follow the instructions given. In the WLAN basic configuration page, enable the WPS function and select the PBC mode in the pop-up menu. Click Apply. Now establish the WPS network on your STA (WI-Fi client) by pressing the WPS button on it. Once the connection is established on the STA, hold down the WPS button on the ONT for five seconds and release it. If the connection is established, then the light starts to blink on the ONT. To check if the connection setup is done correctly, press the WPS button on the ONT. As soon as you click the WPS button on the ONT, the WPS function on the STA must be enabled within two minutes. If not, then re-perform the same process. Similarly to use the AP-PIN & PIN WPS mode, enable the WPS on the ONT and select PIN/ AP-PIN in the pop-up menu of the WPS mode and click the Apply button. After that, follow the establish the WPS network on ONT as discussed above.
To enable the WPS option on your router, perform the steps as given below.
To fix the WPS is Turned On issue, follow the troubleshooting instructions as given below.
First, press the WPS button on the device, such as a printer. After you start the WPS mode on your device, you must locate and tap the WPS button on your wireless access point. After two to three minutes, the router and your device will be linked