Do you see your Belkin router blinking red light? Probably there might be a communication breakdown between the router and modem. Sometimes, this error may happen if there is a problem with the Internet connection. To stop the Belkin router flashing red light, go through the troubleshooting steps given below.
Checking The Dsl Modem:
First, check if the Ethernet cable from the router is properly plugged into your modem.
Restart your modem and check if the Internet connection is stable.
If the router LED has not stopped blinking, unplug the Ethernet cable and power adapter from your modem.
After a few minutes, reconnect the cables and turn on your modem.
Directly connect your computer to your modem via an Ethernet cable and check if the Internet connection is stable. If not, contact your ISP to resolve the Internet connection issue.
If everything is OK, go to the next step.
Restarting The Router:
Start by unplugging your router's power cord from the power source.
Remove all the Ethernet cables connected to your router.
Wait for at least 10 seconds and then reconnect the power cord to the power supply.
Connect your router and modem using the Ethernet cable and turn on the router. Doing so will re-establish the communication with your modem.
If still your Belkin router blinking red light, reset the router settings to factory defaults.
Performing The Factory Reset From The Router:
Go to your router and locate the Reset button.
Disconnect the Ethernet cables connected to the router.
Press and hold the Reset button using a paperclip for at least 10 seconds or until the LED flashes.
Once the router light becomes solid, the reset is complete.
Alternate Method: Factory Reset From The Router Setup Page
To begin with, connect your router and computer.
Open the default browser and type your router's IP address in the URL field. Hit the Enter key to open the login page.
Input your login credentials to log in to your router's setup page.
Once you have logged in to the setup page, click the Restore Factory Default button below Utilities.
Under the Restore factory defaults section, click the Restore Defaults button to restore your router settings to factory defaults.
After completing the reset, remember to reconfigure the router settings on the setup page.
Now, the Belkin router blinking red light issue should be fixed. To get more assistance on Belkin Router Blinking issue, Call us and get instant solution.