How To Configure Belkin N450 Db-F9k1105 Setup?

Belkin N450 Db-F9k1105 Setup

In this section you will learn how to perform belkin n450 Db-F9k1105 setup. Belkin N450 is a dual-band wireless router that supports 802.11n Gigabit wireless connection and has four Gigabit Ethernet ports. Using this router, you can connect your 802.11n/g/b wireless computer or device to a high-speed Internet connection. It supports both 2.4GHz and 5GHz bands for connectivity.

Some of the features offered by this dual-band wireless router/modem are listed below.

  • Integrated 802.11n wireless access point
  • It comes with a NAT technology
  • Web-based Advanced user interface
  • Belkin Router Monitor
  • Integrated 4-Port 10/100 switch

What’s Inside?

Check whether the following components are provided inside the box:

  • Belkin N-450 wireless dual-band N router
  • Ethernet cable
  • Power supply cable
  • Network information card
  • Belkin Setup CD with user manual
  • Quick Setup guide

Note: The Ethernet cable, power supply cable, and network information card are attached to the router.

If you haven’t performed the Belkin N450 Db-F9k1105 setup for the first time, then carry out the simple instructions given below to perform the same.

Preparation For Setup

System requirements:

  • Broadband Internet connection
  • A computer installed with a network interface adapter and TCP/IP networking protocol
  • OS running in Windows XP SP3 or higher, Windows Vista, or Windows 7, or macOS X v10.5 or above

Position the Belkin router:

  • Make sure that the Belkin router is placed close to your modem.
  • Similarly, make sure that your modem is connected to an active and stable Internet connection.
  • Check whether any electromagnetic device is placed in between the modem and your router. If yes, remove it.

Continue reading the below given steps to know more about the Belkin N450 Db-F9k1105 Setup

Steps To Perform Belkin N450 Db-f9k1105 Router Setup.

  • Initially, make sure that your modem is turned off.
  • Now, connect your Belkin router to the modem using the attached Ethernet cable.
  • Insert the router’s power supply cable into an electrical outlet.
  • Now, turn on the modem followed by the router.
  • Once the router lights become idle, insert the router’s setup CD into your computer.
  • Wait for the installer file to open automatically.
  • If it fails to open, then open the file by double-clicking on it.
  • When prompted, type the default username and password of your router in the given field. (Note: You can find the default credentials at the bottom of the router.)
  • Set up the belkin router's basic settings by following the on-screen instructions.
  • Once the Belkin N450 DB-F9K1105 router setup is done, the Success! message will appear on the screen.

To know more about the Belkin N450 Db-F9k1105 setup, contact us and get fine solution.