How To Stop Att Router Blinking Red?

Att router blinking red

When you try to connect your devices to your ATT router’s network, you might face network issues resulting in connection failure. On an ATT router, the Att router blinking red light indicates the network connection problem. This might be caused due to different reasons. Read more to learn the solutions to fix the red light blinking issue on an ATT router.

1. Verify the cable connections:

  • If you are using a wired network connection between the router and your devices, make sure the cables are not damaged.
  • If the network cables are damaged, replace them with new ones and try to connect again.
  • In case of loose cable connection, tighten the cable at the ends and check the connection status.

2. Reboot the router:

  • Even after trying for a long time, if you cannot resolve the Att router blinking red issue of the router, try out the below steps.
  • Disconnect the router’s power cord and wait for some time.
  • Now, plug the power cord to the router and enable the wireless network of the ATT router.
  • See that the devices connect to the router network. If not, restart the router and move to the next solution.

3. Restart the modem:

  • If you are using a modem to connect the router to the ISP, turn off the modem and router.
  • After a while, provide the power connection to the modem. Following that, turn on the router as well.
  • If the restart does not solve the issue, proceed to reset the modem.

4. Try different power socket:

  • At times, you might find that there are no issues with the hardware and software settings of the router. But still, there might be a problem with the network connection on the router.
  • If that is the case, then plug the power cord of the router to another electrical wall socket and check the connection and Att router blinking red issue.