How Do I control Arris Router Bandwidth?

Proceed with the steps that are given below to Control Arris Router Bandwidth.

Make sure to configure the router and connect it to your computer.

You can connect the router to your computer either using an Ethernet cable or connect it wirelessly.

Press the Windows and R buttons together on your computer to open the Run dialog box.

Type “cmd” in the Search section. Then, press the Enter key.

Now, the Command Prompt window will be opened.

Type “ipconfig” and locate the IP address of the Arris router in the Default Gateway section.

Open your browser and enter the IP address in the URL section.

Enter the username and password of the router.

The default username is admin and password is password.

Once you have entered the credentials for authentication, click on the Log In button.

Once you are on the web interface page of the Arris router, you can set the settings to control the bandwidth.

Click on the LAN Setup tab and then click the DHCP option in the left panel to view the clients connected to your arris router.
Next, click the Wireless Setup tab at the top.
In the Wireless Setup menu, click the Advanced option in the left panel.
The Channel Bandwidth option can be seen under the 80211n Specific Settings section.
You have two options --- 20 MHz and 20/40 MHz --- in the Channel Bandwidth menu. It will be set to 20 MHz by default.
Make sure to save the settings after configuration by clicking the Apply button.
After setting the bandwidth, check the speed of the internet by opening a web page.
You can run a speed test to check the speed of the internet connection.
If you find the speed is low, you can again modify the bandwidth settings from the web interface page of the router. I will hope the above steps will be helpful to Control Arris Router Bandwidth.

How To Control Arris Router Bandwidth?